Question 1
According to Austrian plaster classification and DIN EN 998-1, which binder combination characterizes Mortar Group P II (lime-cement plaster / Kalkzementputz, Mortar class CS II)?
Correct Answer:
Hydraulic lime or aerial lime combined with Portland cement as co-binder, balanced with mineral aggregates.
Question 2
A newly poured concrete wall exhibits a glossy, brittle surface layer known as a sinter skin (Sinterschicht). Why is this layer detrimental to subsequent coatings, and how must it be removed?
Correct Answer:
The sinter skin consists of fine cement paste and release agents with low cohesive tensile strength and low porosity; it must be mechanically removed by diamond grinding or sweep blasting.
Question 3
When measuring the residual moisture (Restfeuchte) of a concrete floor slab using the Calcium Carbide Method (CM-Gerät) prior to installing a vapor-tight 2K epoxy floor coating, what is the maximum permissible moisture limit?
Correct Answer:
Maximum 2.0 CM-% (or 1.5 CM-% for heated screeds)
Question 4
A master painter observes crystalline white efflorescence (Ausblühungen) on an exterior brick and mineral plaster facade. What is the correct diagnostic evaluation and remediation procedure?
Correct Answer:
The efflorescence consists of water-soluble mineral salts transported by moisture; the substrate must be dried, the moisture source eliminated, and salts removed dry by brushing without water.
Question 5
Freshly applied mineral lime-cement plaster exhibits a strongly alkaline pH of 12.0 to 13.0. What chemical failure occurs if a standard solvent-borne alkyd resin enamel is applied directly onto this fresh substrate?
Correct Answer:
Saponification (Verseifung): the alkaline calcium hydroxide hydrolyzes the ester bonds of the alkyd resin, resulting in a sticky, non-drying, and discolored film.
Question 1
Exam overview

About this Exam

Prepare with the Meisterprüfung Maler und Anstreicher Practice Questions - Meisterprüfung Maler und Anstreicher (Austria) Exam practice quiz. This question bank includes 100 questions covering paint, coating, exterior, component, and master. Use it to review important concepts, identify knowledge gaps, and build confidence for the related exam, course, or assessment.

More details

Additional Information

Meisterprüfung Maler und Anstreicher Practice Questions - Meisterprüfung Maler und Anstreicher (Austria) Exam

This practice set contains 100 questions from the matching question bank and focuses on paint, coating, exterior, component, and master. Work through each question carefully, review the provided solutions, and revisit topics that need more study before your next attempt.

This is an independent study resource intended for practice and review; it is not an official examination or an endorsement by any organization named in the title.

Quiz information

Frequently Asked Questions

The complete question count is available after full access is unlocked.
No fixed duration is currently configured for this quiz.
Question explanations are included where they are available in the quiz content, helping you review the reasoning after answering.
Yes. You can retake the practice test again as you continue studying during your available access period.
After your access is confirmed, you can continue into the complete practice exam from this quiz flow.
Unless explicitly stated otherwise, this page provides independent practice material for study and exam preparation and is not the official examination itself.
Keep studying

Related Questions