AZ ROC C-56 Welding Practice Questions - Arizona ROC C-56 Welding Examination Exam

Access More Questions

When setting up an oxyfuel cutting torch to cut a 1-inch thick carbon steel plate, how should the cutting tip size and oxygen pressure compare to those used for a 1/4-inch plate?

A larger cutting tip orifice and higher cutting oxygen pressure are required The same tip size is used, but fuel gas pressure is tripled A smaller cutting tip orifice and lower oxygen pressure are used to concentrate heat Tip size remains unchanged, but travel speed must be increased

Correct Answer:

A larger cutting tip orifice and higher cutting oxygen pressure are required

Access more questions from this quiz

Continue to AZ ROC C-56 Welding Practice Questions - Arizona ROC C-56 Welding Examination Exam for more practice questions and the full quiz experience.

Access More Questions