NM CID GF-3 Practice Questions - New Mexico CID GF-3 Canals, Reservoirs Or Irrigation Systems Contractor Examination Exam

Access More Questions

A common design limit on velocity in thermoplastic irrigation pressure pipe is about 5 feet per second because higher velocity:

Always increases precipitation rate in inches per hour Increases friction loss, water hammer, and wear at fittings Is required by OSHA Subpart P Prevents the need for a backflow preventer

Correct Answer:

Increases friction loss, water hammer, and wear at fittings

Access more questions from this quiz

Continue to NM CID GF-3 Practice Questions - New Mexico CID GF-3 Canals, Reservoirs or Irrigation Systems Contractor Examination Exam for more practice questions and the full quiz experience.

Access More Questions