Seabee BU A School Wall And Floor Tile, Trim, And PEB Practice Test

Sag rods are used to hold the Holden column and bottom of the wall panel.

Purlins and girts End wall parts Holden column and bottom of wall panel Door jamb

Correct Answer:

Holden column and bottom of wall panel

Explanation:

Sag rods act as temporary braces that keep the Holden column and the bottom edge of the wall panel aligned and from sagging as the wall is erected. By pulling these points into the correct position and holding them steady, they provide the stability needed for accurate fastening and for the wall to stay plumb until the permanent members are in place. Purlins and girts are used to support roof and wall framing rather than brace the Holden column, while end wall parts and door jamb refer to other components of the structure.

Access more questions from this quiz

Continue to Seabee BU A School Wall and Floor Tile, Trim, And PEB Practice Test for more practice questions and the full quiz experience.

Access More Questions