2026 Nevada DMV Double Endorsement Test 2 (20 Questions And Complete Answers)
DMV20 Terms|2026 Nevada DMV Double Endorsement Test 2 (20 Questions And Complete Answers)
1 / 20
Terms in this set
20
Radial and bias-ply tires:
1. Should be used together.
2. Should be used together on the front of a vehicle.
3. Should not be used together.
Should not be used together.
When backing a trailer, you must first turn the steering wheel:
1. In the direction you want the trailer to go.
2. In the direction opposite of where you want the trailer to go.
3. To the left.
In the direction opposite of where you want the trailer to go.
When a construction worker is close to the road, you should:
1. Increase your speed.
2. Decrease your speed.
3. Not drive in any lane.
4. Wait to proceed until the construction is complete.
Decrease your speed.
If you are being tailgated, you should:
1. Drive on the shoulder.
2. Pull off the roadway.
3. Drive faster.
4. Allow the vehicle to pass.
Allow the vehicle to pass.
A stopped bus:
1. Is not a cause for concern since it is stopped.
2. Is only a concern if passengers are exiting the bus.
3. Is a concern whether or not passengers are visible.
Is a concern whether or not passengers are visible.
Rearward amplification refers to:
1. The amount of noise projected to the rear of a vehicle.
2. The cause of the "crack-the-whip" effect.
3. The number of trailers that can be pulled by a tractor.
The cause of the "crack-the-whip" effect.
If an aggressive driver is involved in a crash on the road ahead of you, you should:
1. Block the driver in with your vehicle.
2. Stop after the crash scene and report the driver’s aggressive behavior to the police.
3. Continue driving and mind your own business.
4. Pull over and yell at the driver.
Stop after the crash scene and report the driver’s aggressive behavior to the police.
If the brakes “pull” to one side or the other when you use them, it's a sign that:
1. The brakes are working properly.
2. The brakes need to be checked.
3. The brakes are new.
4. The brakes have too much stopping power.
The brakes need to be checked.
To use the controlled braking method, you should:
1. Apply the brakes as hard as possible without locking the wheels.
2. Apply the brakes with about half-force.
3. Apply the brakes until the wheels lock.
4. Pump the brakes.
Apply the brakes as hard as possible without locking the wheels.
Vehicles with low underneath clearance may be difficult to drive:
1. Over railroad crossings.
2. In rural areas.
3. On wet roads.
Over railroad crossings.
Showing the first 10 terms. Use the flashcard player above to study all 20 terms!