2026 Maryland DMV Knowledge Test Class B Test 1 (50 Questions And Complete Answers)
1 / 50
Terms in this set
50
An empty truck:
1. Requires a shorter stopping distance than a full truck.
2. Requires a longer stopping distance than a full truck.
3. Takes the same distance to stop as a full truck.
1. Requires a shorter stopping distance than a full truck.
2. Requires a longer stopping distance than a full truck.
3. Takes the same distance to stop as a full truck.
Requires a longer stopping distance than a full truck.
When checking the power steering fluid during a vehicle inspection, you will need to do each of the following, except:
1. Show where the power steering fluid dipstick is located.
2. Check for adequate power steering fluid.
3. Ensure that the power steering fluid level is above the full mark.
4. Ensure that the power steering level is above the refill mark.
1. Show where the power steering fluid dipstick is located.
2. Check for adequate power steering fluid.
3. Ensure that the power steering fluid level is above the full mark.
4. Ensure that the power steering level is above the refill mark.
Ensure that the power steering fluid level is above the full mark.
A steering wheel should be held:'
1. With both hands.
2. With one hand, keeping the other hand free for other tasks.
3. With one hand at a time, alternating between hands.
4. At the base of the wheel.
1. With both hands.
2. With one hand, keeping the other hand free for other tasks.
3. With one hand at a time, alternating between hands.
4. At the base of the wheel.
With both hands.
When leaving your vehicle, you should:
1. Apply the parking brake.
2. Apply the air brakes.
3. Not apply any brake.
4. Disconnect the trailer.
1. Apply the parking brake.
2. Apply the air brakes.
3. Not apply any brake.
4. Disconnect the trailer.
Apply the parking brake.
Which of the following is not part of a vehicle’s air brake system?
1. Air gauges
2. Low pressure warning device
3. Air filter
1. Air gauges
2. Low pressure warning device
3. Air filter
Air filter
How much water needs to be on the surface of a road for a vehicle to hydroplane?
1. Usually several inches
2. A good amount, such as a large puddle
3. A small amount
4. None
1. Usually several inches
2. A good amount, such as a large puddle
3. A small amount
4. None
A small amount
If hydraulic brakes fail, a driver can reduce their speed by:
1. Shifting into a higher gear.
2. Shifting into a lower gear.
3. Finding a hill.
4. Letting the truck run out of gas.
1. Shifting into a higher gear.
2. Shifting into a lower gear.
3. Finding a hill.
4. Letting the truck run out of gas.
Shifting into a lower gear.
Before beginning to drive downhill, you should:
1. Take your vehicle out of gear.
2. Shift into a lower gear.
3. Move into the left lane.
1. Take your vehicle out of gear.
2. Shift into a lower gear.
3. Move into the left lane.
Shift into a lower gear.
Once stopped as part of the stop/start maneuver, you should:
1. Apply the parking brake.
2. Keep the vehicle in first gear.
3. Be perpendicular to the curb.
4. Be blocking a driveway.
1. Apply the parking brake.
2. Keep the vehicle in first gear.
3. Be perpendicular to the curb.
4. Be blocking a driveway.
Apply the parking brake.
When entering a foggy area, you should:
1. Stop on the side of the roadway.
2. Pass other vehicles.
3. Slow down.
4. Use your high beam headlights.
1. Stop on the side of the roadway.
2. Pass other vehicles.
3. Slow down.
4. Use your high beam headlights.
Slow down.
Showing the first 10 terms. Use the flashcard player above to study all 50 terms!