2026 Kansas DMV Air Brakes Class A Test 2 (25 Questions And Complete Answers)
DMV25 Terms|2026 Kansas DMV Air Brakes Class A Test 2 (25 Questions And Complete Answers)
1 / 25
Terms in this set
25
The air storage tanks:
1. Hold only enough air for one braking cycle.
2. Hold enough air for brakes to be used several times if the compressor stops working.
3. Do not hold air unless there is an emergency.
4. Hold enough air for more than 1,000 braking cycles.
Hold enough air for brakes to be used several times if the compressor stops working.
Air tank drains:
1. Allow rain water to enter the tank.
2. Are used to drain water and compressor oil from the air tank.
3. Should never be opened.
4. Must remain open during transit.
Are used to drain water and compressor oil from the air tank.
What do anti-lock brakes do?
1. Help a driver avoid wheel lockup
2. Lock up the front wheels
3. Prevent a vehicle from accelerating while traveling uphill
4. Prevent a vehicle from accelerating while traveling downhill
Help a driver avoid wheel lockup
The parking brake should be:
1. Used whenever you park your vehicle.
2. Used while driving.
3. Set when driving in bad weather.
4. Removed.
Used whenever you park your vehicle.
Vehicles with dual air brake systems:
1. Maintain full-capacity air pressure in the braking systems even when the vehicle is not running.
2. Maintain some air pressure in the braking systems when the vehicle is not running.
3. Must be run to build enough air pressure to brakes to operate properly.
4. Do not need time to build air pressure before a trip.
Must be run to build enough air pressure to brakes to operate properly.
Test the low pressure warning signal:
1. Once a month.
2. Once a week.
3. Twice a week.
4. Before every trip.
Before every trip.
When the brake pedal is pushed down, air brakes work:
1. Immediately.
2. After a short delay.
3. After about a minute.
4. Only if it is warm outside.
After a short delay.
In cold weather, an alcohol evaporator should be checked and filled:
1. Once a week.
2. Every day.
3. Every hour.
4. Once a month.
Every day.
How is the parking brake released?
1. By tapping on the brake pedal three times
2. By pushing in the brake control knob
3. By engaging the accelerator
4. By tapping the accelerator twice
By pushing in the brake control knob
To ensure normal stopping power, drivers of vehicles equipped with a front brake limiting valve should:
1. Set the control to normal.
2. Set the control to the off position.
3. Set the control to neutral.
4. Keep the control at the halfway mark.
Set the control to normal.
Showing the first 10 terms. Use the flashcard player above to study all 25 terms!