2026 District Of Columbia DMV Bus Endorsement Test 1 (20 Questions And Complete Answers)
1 / 20
Terms in this set
20
During a vehicle inspection, be sure that:
1. The emergency exits are difficult to open.
2. The emergency exits squeak.
3. The emergency exit warning devices work properly.
4. The emergency exits are not accessible from inside the cab.
1. The emergency exits are difficult to open.
2. The emergency exits squeak.
3. The emergency exit warning devices work properly.
4. The emergency exits are not accessible from inside the cab.
The emergency exit warning devices work properly.
When performing the stop/start maneuver as a part of the skills test, you should:
1. Cut off other vehicles if needed to get onto the shoulder.
2. Not use any turn signals.
3. Slam on the brakes to stop as quickly as possible.
4. Decelerate smoothly.
1. Cut off other vehicles if needed to get onto the shoulder.
2. Not use any turn signals.
3. Slam on the brakes to stop as quickly as possible.
4. Decelerate smoothly.
Decelerate smoothly.
During the on-road driving test, you must do all of the following, except:
1. Wear your safety belt.
2. Obey all traffic laws.
3. Complete the test without a moving violation.
4. Obey all traffic signs and signals, but only if other traffic is present.
1. Wear your safety belt.
2. Obey all traffic laws.
3. Complete the test without a moving violation.
4. Obey all traffic signs and signals, but only if other traffic is present.
Obey all traffic signs and signals, but only if other traffic is present.
Which of the following is not acceptable emergency equipment?
1. Three red reflective triangles
2. Six fuses
3. Three liquid burning flares
4. Four yellow squares
1. Three red reflective triangles
2. Six fuses
3. Three liquid burning flares
4. Four yellow squares
Four yellow squares
In a school bus, where is the overhead inside rearview mirror located?
1. Above the windshield on the driver’s side of the bus
2. Above the emergency door in the rear
3. Under the driver's seat
4. Above the door on the passenger side of the bus
1. Above the windshield on the driver’s side of the bus
2. Above the emergency door in the rear
3. Under the driver's seat
4. Above the door on the passenger side of the bus
Above the windshield on the driver’s side of the bus
After students unload at a school, the driver:
1. May assume students have taken all of their belongings with them.
2. Should walk through the bus and check for any sleeping or hiding students.
3. Should assume the students have immediately cleared the doorway.
4. May turn off the dispatch radio.
1. May assume students have taken all of their belongings with them.
2. Should walk through the bus and check for any sleeping or hiding students.
3. Should assume the students have immediately cleared the doorway.
4. May turn off the dispatch radio.
Should walk through the bus and check for any sleeping or hiding students.
A school bus must be evacuated if:
1. The bus has stalled in winter weather conditions.
2. The air conditioning system has broken.
3. There is any imminent danger of collision.
4. Students are getting motion sickness.
1. The bus has stalled in winter weather conditions.
2. The air conditioning system has broken.
3. There is any imminent danger of collision.
4. Students are getting motion sickness.
There is any imminent danger of collision.
When checking the springs during a vehicle inspection, do all of the following, except:
1. Look for missing leaf springs.
2. Look for broken coil springs.
3. Ensure torsion springs are not damaged.
4. Glue cracked leaf springs.
1. Look for missing leaf springs.
2. Look for broken coil springs.
3. Ensure torsion springs are not damaged.
4. Glue cracked leaf springs.
Glue cracked leaf springs.
If approaching a railroad crossing while driving a placarded vehicle, you should always:
1. Activate your four-way flashers.
2. Stop within five feet of the tracks.
3. Change gears while on the tracks.
4. Change lanes while on the tracks.
1. Activate your four-way flashers.
2. Stop within five feet of the tracks.
3. Change gears while on the tracks.
4. Change lanes while on the tracks.
Activate your four-way flashers.
When unloading students at a school, the driver should:
1. Secure the bus by turning off the ignition switch.
2. Keep the key in the ignition and leave the driver’s compartment.
3. Read a book while students unload.
4. Not be on the bus.
1. Secure the bus by turning off the ignition switch.
2. Keep the key in the ignition and leave the driver’s compartment.
3. Read a book while students unload.
4. Not be on the bus.
Secure the bus by turning off the ignition switch.
Showing the first 10 terms. Use the flashcard player above to study all 20 terms!